Strength · touchscreen / Foundry process control
SWY-IIISIntelligent Sand Universal Strength Tester
A touchscreen strength tester for green sand compression, shear, tensile, and bending tests.
SWY-IIIS
Configuration and sensor set confirmed at quotation.
01 / Why this configuration
Built around a real measurement decision.
The SWY-IIIS measures the strength of standard green-sand and core-sand specimens. The touchscreen shows real-time and peak force, and the load range covers routine foundry strengths.
A touchscreen strength tester for green sand compression, shear, tensile, and bending tests. The final specification is matched to the material range, sample form, and reporting requirement of your laboratory or production line.
02 / Configuration
Key specifications.
Use these as a starting point. Utility requirements, calibration ranges, and acceptance criteria are confirmed against the final configuration.
Have the material list or a drawing? Send it with the application so the configuration can be reviewed properly.
Request a configuration| Maximum force | 3 kN / 15 kN |
|---|---|
| Stroke | 50 mm |
| Compression range | 0–7.639 MPa |
| Tensile range | 0–12.000 MPa |
| Shear range | 0–1.200 MPa |
| Bending range | 0–96.600 MPa |
| Power | AC 220 V / 50 Hz |
| Application | Green sand and coated sand |
Indicative configuration information. Final datasheet and performance specification are issued with the quotation and confirmed at order.
03 / Where it fits
Applications and materials.
Foundry process control supports decisions across incoming material, production control, and final verification. The right method depends on the question the result has to answer.
See how we support the installation- Green sand compression strength
- Core sand tensile strength
- Coated sand hot strength
- Moulding sand control
- Bentonite evaluation
- Quality documentation
Typical materials
If your alloy or sample form is not listed, send the details. Configuration is not limited to the examples shown here — but every recommendation should be checked against the actual material and measurement target.
Before you specify
SWY-IIIS — practical answers.
Still deciding? Send the material and the measurement target — we will reply with a practical next step.
Ask an application engineerWhat is the SWY-IIIS used for?
A touchscreen strength tester for green sand compression, shear, tensile, and bending tests. The configuration is matched to the material range, sample form and reporting requirement of the laboratory or production line.
Which materials and sample forms does the SWY-IIIS cover?
Typical materials: Green sand, Core sand, Coated sand, Resin sand. Typical tasks: green sand compression strength, core sand tensile strength. If the material or sample form is not listed, send the details before committing — the configuration is not limited to the examples shown.
What are the key specifications of the SWY-IIIS?
Starting point: maximum force 3 kN / 15 kN; stroke 50 mm; compression range 0–7.639 MPa. These figures are indicative; utility requirements, calibration ranges and acceptance criteria are confirmed with the final configuration.
How is the configuration confirmed before ordering?
Send the material list, the sample form, the standard and the decision the result has to support. We confirm the configuration in the quotation, and a sample test can be arranged where the result is critical.
Put it to work
Configure SWY-IIIS around your material.
Send the alloy, sample form, elements of interest, and the decision the result needs to support. We will recommend a configuration and confirm the next step.