AEC620 · dual frequency / Non-destructive testing
AEC620Portable Eddy Current Flaw Detector
A portable dual-frequency eddy current detector for surface and near-surface cracks.
AEC620
YuBoo Instrument / Luoyang, China
01 / Why this configuration
Built around a real measurement decision.
The AEC620 is a portable eddy current instrument with two independent frequencies, digital balance and multiple display modes. It is used for surface crack detection on metal parts, tubes and welds, with conductivity and thickness modules available through the appropriate sensors.
A portable dual-frequency eddy current detector for surface and near-surface cracks. The final specification is matched to the material range, sample form, and reporting requirement of your laboratory or production line.
02 / Configuration
Key specifications.
Use these as a starting point. Utility requirements, calibration ranges, and acceptance criteria are confirmed against the final configuration.
Have the material list or a drawing? Send it with the application so the configuration can be reviewed properly.
Request a configuration| Frequency | 10 Hz–10 MHz |
|---|---|
| Channels | 2 independent |
| Gain | 0–99 dB |
| Phase | 0–359° |
| Display | 5.7-inch TFT |
| Recording | 8 GB / 24 h |
| Power | 110–220 V, Li battery |
| Lift-off | 1–3 mm |
Indicative configuration information. Final datasheet and performance specification are issued with the quotation and confirmed at order.
03 / Where it fits
Applications and materials.
Non-destructive testing supports decisions across incoming material, production control, and final verification. The right method depends on the question the result has to answer.
See how we support the installation- Surface cracks
- Tube inspection
- Weld inspection
- Metal parts
- Conductivity checks
- Thickness measurement
Typical materials
If your alloy or sample form is not listed, send the details. Configuration is not limited to the examples shown here — but every recommendation should be checked against the actual material and measurement target.
Before you specify
AEC620 — practical answers.
Still deciding? Send the material and the measurement target — we will reply with a practical next step.
Ask an application engineerWhat is the AEC620 used for?
A portable dual-frequency eddy current detector for surface and near-surface cracks. The configuration is matched to the material range, sample form and reporting requirement of the laboratory or production line.
Which materials and sample forms does the AEC620 cover?
Typical materials: Aluminium, Stainless steel, Carbon steel, Copper alloys. Typical tasks: surface cracks, tube inspection. If the material or sample form is not listed, send the details before committing — the configuration is not limited to the examples shown.
What are the key specifications of the AEC620?
Starting point: frequency 10 Hz–10 MHz; channels 2 independent; gain 0–99 dB. These figures are indicative; utility requirements, calibration ranges and acceptance criteria are confirmed with the final configuration.
How is the configuration confirmed before ordering?
Send the material list, the sample form, the standard and the decision the result has to support. We confirm the configuration in the quotation, and a sample test can be arranged where the result is critical.
Put it to work
Configure AEC620 around your material.
Send the alloy, sample form, elements of interest, and the decision the result needs to support. We will recommend a configuration and confirm the next step.