Notch verification · 50× / Mechanical testing
XT-50Impact Specimen Notch Projector
A 50× optical projector for checking Charpy V and U notch geometry before impact testing.
XT-50
YuBoo Instrument / Luoyang, China
01 / Why this configuration
Built around a real measurement decision.
The XT-50 projects the notch profile at 50× onto a 180 mm screen, where it can be compared with the standard V or U notch template. It is a simple visual check that the specimen notch has been prepared correctly.
A 50× optical projector for checking Charpy V and U notch geometry before impact testing. The final specification is matched to the material range, sample form, and reporting requirement of your laboratory or production line.
02 / Configuration
Key specifications.
Use these as a starting point. Utility requirements, calibration ranges, and acceptance criteria are confirmed against the final configuration.
Have the material list or a drawing? Send it with the application so the configuration can be reviewed properly.
Request a configuration| Method | Optical projection |
|---|---|
| Magnification | 50× |
| Screen diameter | 180 mm |
| Work table | 110 × 125 mm square; Ø90 mm round |
| Travel | ±10 mm longitudinal/lateral; ±12 mm lift |
| Rotation | 0–360° |
| Light source | 12 V / 100 W halogen |
| Dimensions | 515 × 224 × 603 mm |
Indicative configuration information. Final datasheet and performance specification are issued with the quotation and confirmed at order.
03 / Where it fits
Applications and materials.
Mechanical testing supports decisions across incoming material, production control, and final verification. The right method depends on the question the result has to answer.
See how we support the installation- Charpy V-notch verification
- Charpy U-notch verification
- Specimen preparation checks
- Impact test quality control
- Laboratory specimen acceptance
- Pre-test documentation
Typical materials
If your alloy or sample form is not listed, send the details. Configuration is not limited to the examples shown here — but every recommendation should be checked against the actual material and measurement target.
Before you specify
XT-50 — practical answers.
Still deciding? Send the material and the measurement target — we will reply with a practical next step.
Ask an application engineerWhat is the XT-50 used for?
A 50× optical projector for checking Charpy V and U notch geometry before impact testing. The configuration is matched to the material range, sample form and reporting requirement of the laboratory or production line.
Which materials and sample forms does the XT-50 cover?
Typical materials: Steel impact specimens, Cast iron specimens, Aluminium specimens, Welded joint specimens. Typical tasks: charpy v-notch verification, charpy u-notch verification. If the material or sample form is not listed, send the details before committing — the configuration is not limited to the examples shown.
What are the key specifications of the XT-50?
Starting point: method Optical projection; magnification 50×; screen diameter 180 mm. These figures are indicative; utility requirements, calibration ranges and acceptance criteria are confirmed with the final configuration.
How is the configuration confirmed before ordering?
Send the material list, the sample form, the standard and the decision the result has to support. We confirm the configuration in the quotation, and a sample test can be arranged where the result is critical.
Put it to work
Configure XT-50 around your material.
Send the alloy, sample form, elements of interest, and the decision the result needs to support. We will recommend a configuration and confirm the next step.